Power and Solar Systems

A repeater that runs out of power disappears from the network. Power system design is as critical as radio configuration for a reliable long-term deployment.

Why solar works for repeaters

MeshCore repeater firmware is designed for low power consumption. A repeater draws very little power when idle and slightly more when forwarding packets. This makes solar deployment practical even with modest hardware.

Sizing your power system

The goal: enough battery to run through several consecutive cloudy days, and a panel large enough to fully recharge on a typical sunny day.

• Solar panel: A 5 - 20W panel mountedis reasonable example sizing for a low-draw repeater, but the right wattage depends on your load and your site's worst-month sun-hours. Mount it south-facing (in North America) and angledangle it roughly to match your latitude for best year-round output.output; if cloudy-season uptime is critical, tilt toward latitude +10-15 degrees to favor winter sun.
• Battery chemistry: LiFePO4 (lithium iron phosphate) is strongly recommended for outdoor use. It tolerates temperaturecold extremesdischarge better than LiPo,well, has a much longer cycle life,life than LiPo, and is significantly safer. However, LiFePO4 (like any lithium chemistry) must NOT be charged below 0 °C / 32 °F - charging when frozen causes permanent lithium plating, reduced cycle life, and a fire risk. For cold climates, use a pack with a low-temperature charge cutoff in its BMS, or add a low-temp charge disconnect. Size for at least 3 - 5several days of runtime without any solar input.input - 3 - 5 days is a common minimum starting point; increase it for cloudy climates or critical links. For emergency-grade deployments, size the battery for your worst-case multi-day low-solar period (often longer than 3 - 5 days in winter) and validate it with a no-charge runtime test before relying on the node.
• Charge controller: Required between panel and battery. MPPT (Maximum Power Point Tracking) controllers are more efficient than PWM, whichespecially mattersin especiallycold/temperate climates and on larger arrays. On very small systems.systems the efficiency gain is modest, and a simple PWM controller is often sufficient and cheaper.

Fuse the battery. Install an inline fuse in the battery positive lead close to the battery, sized per your controller and wiring. A LiFePO4 cell can deliver very high fault current; an unfused short can start a fire. Wire in order: battery → charge controller → panel.

Mains power

For rooftop installations with building power access, mains power plus a battery backup is more reliable than solar alone. Use a quality regulated supply and consider a small UPS to ride out brief power interruptions.

Power optimization

• Disable unused features: display backlight, Bluetooth, WiFi (if present on the board)
• Set a long flood advertisement interval tofor fixed infrastructure - the MeshCore default is commonly 12 hourshours, set via set flood.advert.interval {hours} (range ~3-168; verify in your firmware version). Note this is separate from the default)zero-hop -advert.interval more(default 0/off). More frequent ads increase power draw with minimal benefitbenefit.
• Do not set TX power higher than necessaryneeded for your coverage goals - transmitthe power amplifier is the largest singlecurrent variabledraw during transmission. On a low-traffic repeater that spends most of its time receiving, idle/RX current may dominate total energy use, so also minimize wake/advertise frequency. TX power drawis also legally capped: 47 CFR 15.247 limits conducted power to 1 W (30 dBm) in 902-928 MHz, reduced dB-for-dB for antennas above 6 dBi.