Recently Updated Pages
Where to Buy Meshtastic and MeshCore Hardware
LoRa mesh hardware is available from multiple sources. Here's a guide to finding the right hardwa...
MeshCore Firmware Distributions
Accurate as of 13 July 2026. Firmware moves fast. Check versions and device counts against the co...
Key Repeater Settings
These settings are most critical for deploying and maintaining MeshCore repeater and room server ...
MeshCore Firmware Variants Explained
Accurate as of 13 July 2026. Firmware version numbers below should be checked against the current...
Flashing MeshCore Firmware OTA: The Definitive Guide
Step-by-Step: OTA Update Over-the-air (OTA) updating lets you reflash a deployed MeshCore node; a...
North American Networks Reference
Active LoRa mesh networks in North America: radio settings and community links only. For what the...
JadeNode Build (~$50)
The JadeNode is one of CascadiaMesh's low-cost (~$50) DIY repeater designs, configured for the st...
MeshCore CLI Configuration
MeshCore nodes can be configured using two distinct CLI systems. The meshcore-cli Python tool dri...
T-Beam Build Guide (TTGO/LilyGO)
Overview The TTGO/LilyGO T-Beam is one of the most popular all-in-one LoRa mesh boards available....
LilyGo T-Beam Setup Guide
⚠ ANTENNA SAFETY - ALL DEVICES: Always connect an antenna before powering on or transmitting with...
LilyGo T-Deck Plus Setup Guide
⚠ ANTENNA SAFETY - ALL DEVICES: As good practice, always connect an antenna before powering on or...
Seeed Wio Tracker Setup Guide
⚠ ANTENNA SAFETY - ALL DEVICES: Always connect an antenna before powering on or transmitting with...
Heltec LoRa 32 Build Guide
Overview The Heltec LoRa 32 is a compact, low-cost development board combining an ESP32-family mi...
Flashing Repeater Firmware
MeshCore-capable LoRa boards typically ship without MeshCore firmware (blank, vendor test firmwar...
Reflashing and Factory Reset
When a MeshCore repeater becomes unreachable, misconfigured, or boot-loops, reflashing is the rec...
LilyGo T-Deck Setup Guide
⚠ ANTENNA SAFETY - GOOD PRACTICE: Always connect an antenna before powering on or transmitting wi...
Nano G2 Ultra Setup Guide
⚠ ANTENNA SAFETY - ALL DEVICES: Always connect an antenna (or a 50-ohm dummy load) before transmi...
Budget MeshCore Repeater: Under $60
Budget MeshCore Repeater: Under $60 Not every deployment calls for a weatherproof solar installat...
Station G2 Setup Guide
⚠ ANTENNA SAFETY - ALL DEVICES: Always connect a properly matched antenna before powering on any ...
Protocol Comparison Reference
This page provides a technical comparison between MeshCore and Meshtastic - the two most widely d...